Newton's Law of Cooling — Definition, Formula & Example
Newton's Law of Cooling is a model for how an object's temperature changes over time as it approaches the temperature of its surroundings. The gap between the object's temperature and the room's temperature shrinks by the same percentage in each equal time interval.
Newton's Law of Cooling states that the rate of change of an object's temperature is proportional to the difference between its temperature and the constant ambient temperature: with . Solving this differential equation gives . The difference therefore undergoes exponential decay toward 0. The model works for cooling () and for warming ().
Key Formula
Where:
- = Temperature of the object at time t
- = Temperature of the surroundings (ambient temperature), assumed constant
- = Initial temperature of the object at t = 0
- = Positive cooling constant that depends on the object and its surroundings, in units of 1 per unit of time
- = Time elapsed since the starting measurement
- = Euler's number, approximately 2.718
Worked Example
Problem: A cup of coffee is poured at 180°F in a room that stays at 70°F. After 10 minutes, the coffee is 125°F. Find the cooling constant , then predict the coffee's temperature after 20 minutes.
Step 1: Substitute , , , and . The starting gap is degrees.
Step 2: Subtract 70 from both sides, then divide by 110. Take the natural log of both sides and solve for .
Step 3: At , the exponent is twice as large, so the gap is halved twice: .
Answer: The cooling constant is per minute. After 20 minutes, the coffee is 97.5°F. It never drops below 70°F, the room temperature.
Why It Matters
Forensic investigators use this model to estimate time of death from body temperature. Food safety rules for cooling cooked food rely on the same idea. In AP Calculus, it is a standard example of a separable differential equation.
Common Mistakes
Mistake: Using and leaving out the ambient temperature. This model predicts that the coffee cools all the way to 0°F.
Correction: Only the difference decays exponentially. Subtract before you divide or take logs, and add back at the end. The temperature levels off at , not at 0.
